With Power Management Turned Off In the Bios Jitters are Very low.Īfter running LCNC latency tests and they were more than acceptable, I installed Path Pilot Hooked to the Tormach PCNC-1100 and had Stable Movement and Function even on the USB Pendant. Linux CNC Latency Tests Bios Defaults Multiple GLX Gear’s & a Movie for a Few Hours. so not sure if this PC will work for the non mesa lpt port people without a LPT card. Under linux lshw it did not show it as a resource. I will assume for testing when i get arround to it that it is lpt1: 378. These PC’s have an LPT header On the PCB for a printer port (Not Tested) Did not find any info on it in the bios like the usual LPT Ports. These Surplus/Government/End of Life PC’s have the Stable G41 Chip Set and Will Accept Mesa 5I25 or 6I25 Yes, That is 2 of them One for the Mill One For the Lathe. You should Look at the very Abundant $50 or less Lenovo M70E’s on Ebay. Looking to Use Tormach Path Pilot Software on a Budget? Testing Surplus PC’s On Linux CNC & PathPilot 1.9.X / PathPilot V2.0
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |